The detailed steps of making and installing the cabled light box are as follows:
1. first of all, the materials are prepared, such as aluminum profiles, accessories (4 small decode each), light box, power supply, lamp cloth, and other tools.
2. according to the 45 degree angle, the four sides can be combined perfectly, and the diagonal diagonal pairs can be in place.
3. the inside and outside side decoding screws are screwed up with a screwdriver, and the screws play a fixed role, so that the frame of the entire lamp box is completed.
4. put the backplane in the box, screw it up, then lay the LED light strip on the floor and fix it with glass glue. Install the power supply on the outer edge of the outlet line (red and blue line respectively).
5. installed on the canvas, the silicon rubber strips already installed around the UV soft film, only the silica gel bar to be embedded in the aluminum frame box, the change is also a way to draw the glue strips out of the painting, fashion, simple design, easy dismantling.
6. the last step is to pin the corners of the four sides to avoid the wound. So the whole lamp box is finished.
The above is the production and installation process of the Li Sen plastic card cloth lamp box.
