Precautions for neon lamp accessories are as follows:
1. Use of plug
When the single wire is made, cut off along both ends of the welding spot, take the light belt with corresponding stroke length, the light belt with the extra part of the stroke length will strip off the silicone shell, keep the internal light belt, cut off the bottom of the extra light belt, the light belt folds back to the silicone shell, in order to avoid the exposure of the bead light line of both ends of the lamp, need to use plug to close both ends.
2. Use of silicone adhesive
(1) single wire production, all lights with joint joint block, curing time of 15 minutes.
Single, double wire production, the bottom section of the connection opening a small amount of smudge bonding use, curing time of 15 minutes.
3. Use of enameled wire
Enameled wire is scratch-free, can be directly welded wire electrified, both silver, divided into two: deep silver, light silver, used to distinguish between positive and negative
All specifications of lights with the bottom section, the use of clips for fixation, exposed the internal positive and negative electrode solder, with our scratch free enameled wire with high temperature solder, positive and negative electrode each for direct welding, which is neon lights out of the use.
Close to the lamp belt at the bottom of the section, the internal connection between the solder joint to form a parallel electrified use.
4. Use of AB glue
Neon light cut butt paste, acrylic milling groove groove bottom paste fixed and acrylic surface paste fixed can be used
Brush liquid A at the neon light notch junction or the bottom of the neon light and wait for 2 seconds. This glue only needs to be brushed once, no need to brush repeatedly, lasting effect.
Apply the B glue to the corresponding appendages to be pasted, and paste directly with the part of the neon light belt that has brushed liquid A, and stick firmly for 2 seconds. Because the paste speed is fast, the strength is large. You need to plan where you want to paste before pasting, and make sure the pasting position is accurate and in place. Note: A/B glue must be mixed in order to achieve A quick and strong paste!
5. Wiring board
It is used to regulate the drawing line of neon lights, and the enameled wire used to make drawing line in the design or text is welded on the wiring board.
6. Light blocking gum
Used for the use of acrylic plate milling groove embedded way, at the bottom of the groove, used to solve the problem of light leakage at the bottom section.
